| Paper |
Title |
Other Keywords |
Page |
| TUPSA030 |
Beam Measurements With Visible Synchrotron Light on VEPP-2000 Collider
|
controls, collider, vacuum, electron |
104 |
| |
- Yu. A. Rogovsky, D. E. Berkaev, A. N. Kyrpotin, I. Nesterenko, A. L. Romanov
BINP SB RAS, Novosibirsk
| |
This paper describes beam diagnostics at VEPP-2000 collider, based on visible synchrotron light analysis. These beam instruments include: SR beamline and optics; acquisition tools and high resolution CCD cameras distributed around the storage ring to measure the transverse beam profile and its position in vacuum chamber; photomultiplier tubes (PMT) which enables beam current measurements; video system. Some applications of these measurement systems and their measurement results are presented.
|
|
|
|
| TUPSA031 |
Profiles and Intensities Measurments in the Diagnostic System of the Extracted Beams of the U-70 Accselerator
|
controls, optics, proton |
107 |
| |
- A. Y. Sotnikov, N. Ivanova, A. V. Koshelev, V. Kovaltsov, A. Lukyantsev, S. Makonin, A. Matyushin, V. Milyutkin, V. S. Seleznev
IHEP Protvino, Protvino, Moscow Region
| |
Diagnostic system for the extracted beams of the U-70 accelerator is a hardware-software complex with profilometers and electronic crates at the lower level, VME-crates with ADC-modules and MVME-167 processors (vxWorks operating system, basic EPICS tools, home made software) at the middle level, personal computers used as workstation at the upper level. In this report we consider: - the approaches to the system adaptation problems during the U-70 runs and solutions to these problems; - data acquisition and hardware-sofware levels of data processing for non-standard profilometers; - the tools for the beam intensity measurement and presentation, the intensimeter calibration procedure.
|
|
|
|
| WEPSB033 |
User Interface in the Diagnostic System of the Extracted Beams of the U-70 Accselerator
|
controls, optics, site |
242 |
| |
- A. Y. Sotnikov, N. Ivanova, A. V. Koshelev, V. Kovaltsov, A. Lukyantsev, V. Milyutkin, Y. N. Smirnov
IHEP Protvino, Protvino, Moscow Region
| |
User interface in the diagnostic system of extracted beams is described. It was developed under Linux operating system on the personal computers used as workstations. The considered program tools provide: - the representation on operator consoles (workstations) information about beam profiles, intensity, displacement, root-mean-square error etc. in different forms; - the dynamic adjustment of the diagnostic system; - web presentation of the currrent information about the extracted beams; - data transfer to physical setups; - special beam characteristics calculation by the profilometer individual units data (for research purposes); - data archiving and web facilities for data viewing.
|
|
|
|