| Title |
Tests of a 3D Printed BPM with a Stretched Wire and with a Particle Beam |
| Authors |
- N. Delerue, D. Auguste, J. Bonis, F. Gauthier, S. Jenzer, A.M. Moutardier
LAL, Orsay, France
|
| Abstract |
We have successfully printed a beam position monitor using 3D printing. After ultra-high vacuum testing and initial measurements with a network analyser we now reports on tests of this BPM using the stretched wire method. The BPM has been installed on a test stand with a wire going through it and electrical pulses have been sent. The signal measured on the pick-ups was compared to that of two conventional BPMs and shows no anomaly specific to the 3D printed BPMs. Following the success of these tests we have also installed this BPM in a beam line at the PhotoInjector at LAL (PHIL). We show that it can give position measurements with an accuracy comparable to that of other BPMs.
|
| Funding |
CNRS/IN2P3 |
| Paper |
download FRXXPLS1.PDF [9.102 MB / 4 pages] |
| Slides |
download FRXXPLS1_TALK.PDF [29.118 MB] |
| Export |
download ※ BibTeX
※ LaTeX
※ Text/Word
※ RIS
※ EndNote |
| Conference |
IPAC2019 |
| Series |
International Particle Accelerator Conference (10th) |
| Location |
Melbourne, Australia |
| Date |
19-24 May 2019 |
| Publisher |
JACoW Publishing, Geneva, Switzerland |
| Editorial Board |
Mark Boland (UoM, Saskatoon, SK, Canada); Hitoshi Tanaka (KEK, Tsukuba, Japan); David Button (ANSTO, Kirrawee, NSW, Australia); Rohan Dowd (ANSTO, Kirrawee, NSW, Australia); Volker RW Schaa (GSI, Darmstadt, Germany); Eugene Tan (ANSTO, Kirrawee, NSW, Australia) |
| Online ISBN |
978-3-95450-208-0 |
| Received |
19 May 2019 |
| Accepted |
22 May 2019 |
| Issue Date |
21 June 2019 |
| DOI |
doi:10.18429/JACoW-IPAC2019-FRXXPLS1 |
| Pages |
4368-4371 |
| Copyright |
 Published by JACoW Publishing under the terms of the Creative Commons Attribution 3.0 International license. Any further distribution of this work must maintain attribution to the author(s), the published article's title, publisher, and DOI. |
|
