| |
The measurement setup is based on wire scanners, optical fibers mounted symmetrically around the beam line over the full length (30 m) of the undulator section, a signal conditioning unit and a data acquisition system. The fiber sensors along the beam line allow the measurement of the spatial distribution of the scattered beam caused by the wire scanner. At each increment of the wire scanner, the generated Cherenkov light in the fiber sensors - which is proportional to the intensity of the scattered electron shower - is measured. As an improvement, the shower is not only measured at a singular location but over the entire length of the undulator section. Each integral of the generated Cherenkov light along the beam line gives one point of the transversal beam profile. Accomplishing an x-y-scan leads to a two dimensional profile of the beam. The synchronisation with the beam trigger allows the characterization of each bunch. The measured data are visualized in real time and stored in a log file for extended evaluation. The high sensitivity of the system allows an accurate monitoring of the beam profile as well as HALO measurement.
|
|