| Paper |
Title |
Page |
| WEPC02 |
Developments at Elettra of the Electronics for the Bunch-Arrival Monitor
|
310 |
| |
- L. Pavlovič, T. Korošec, M. Vidmar
Uni LJ, Ljubljana
- M. Ferianis, F. Rossi
ELETTRA, Basovizza, Trieste
- K. E. Hacker, F. Löhl, H. Schlarb
DESY, Hamburg
|
|
| |
Within the framework of the EUROFEL project, a task has been started in 2006 for a joint development of a Bunch Arrival Monitor (BAM), based on the original idea from DESY. ELETTRA is responsible for the development of the VME-controlled clock-delay board of the BAM system. A variable clock-delay circuit (a phase shifter) is required to adjust the acquisition sampling point of the pick-up-modulated optical pulses of the master-laser oscillator. Since the optical pulses have a repetition rate of 40.625MHz (54MHz in the future) and the acquisition sampling frequency is double of this value, the clock-delay module operates in the 80-120MHz frequency range. The clock timing jitter of the acquisition system greatly affects the measurements of the system: the output timing jitter from the clock-delay board should be less than 0.5ps-rms. Therefore, due to the very strict additive timing-jitter requirements, three phase shifter versions were designed, built and phase-noise evaluated. Low-pass-filter implementation achieved 563fs (at 283fs source jitter) of total-system timing jitter, integrated IQ multiplier 365fs (at 188fs of source) and passive IQ modulator 265fs (at 208fs of source).
|
|