SRF2013 - List of Keywords (heavy-ion)

Paper	Title	Other Keywords	Page
MOIOA05	SRF in Heavy Ions Projects	cavity, linac, ion, cryomodule	30
	D. Jeon IBS, Daejeon, Republic of Korea
	SRF technologies are widely applied to heavy ion accelerator projects in the world such as the RAON, C-ADS, HIAF, FRIB, SPIRAL2, ISAC-II, HIE-ISOLDE etc. In this talk, status report, design choices and SRF challenges met in heavy ion machines are presented.
	Slides MOIOA05 [10.228 MB]

THP039	Design of a Triple-Spoke Cavity as a Rebuncher for RIKEN RI-Beam Factory	cavity, factory, simulation, acceleration	988
	L. Lu RIKEN, Saitama, Japan O. Kamigaito, N. Sakamoto, K. Suda, K. Yamada RIKEN Nishina Center, Wako, Japan
	A superconducting triple-spoke cavity as a rebuncher for very heavy ion beams such as uranium at β=0.303 for RIKEN RI-beam factory is designed. The required total gap voltage is 3 MV. In this design, thick ribs (25 mm) are placed on the both ends of cavity so that the deformation caused by pressure of liquid helium is less than 0.5 mm. A copper test model with one spoke is designed to be fabricated using the same technique as that for Nb cavity. The detailed design will be presented.

Paper

Title

Other Keywords

Page

MOIOA05

SRF in Heavy Ions Projects

cavity, linac, ion, cryomodule

30

D. Jeon
IBS, Daejeon, Republic of Korea

SRF technologies are widely applied to heavy ion accelerator projects in the world such as the RAON, C-ADS, HIAF, FRIB, SPIRAL2, ISAC-II, HIE-ISOLDE etc. In this talk, status report, design choices and SRF challenges met in heavy ion machines are presented.

Slides MOIOA05 [10.228 MB]

THP039

Design of a Triple-Spoke Cavity as a Rebuncher for RIKEN RI-Beam Factory

cavity, factory, simulation, acceleration

988

L. Lu
RIKEN, Saitama, Japan
O. Kamigaito, N. Sakamoto, K. Suda, K. Yamada
RIKEN Nishina Center, Wako, Japan

A superconducting triple-spoke cavity as a rebuncher for very heavy ion beams such as uranium at β=0.303 for RIKEN RI-beam factory is designed. The required total gap voltage is 3 MV. In this design, thick ribs (25 mm) are placed on the both ends of cavity so that the deformation caused by pressure of liquid helium is less than 0.5 mm. A copper test model with one spoke is designed to be fabricated using the same technique as that for Nb cavity. The detailed design will be presented.